Aluminium Honeycomb Panel
Aluminium honeycomb panels usually range from 10mm-50mm thickness. The aluminium core is essentially shaped with the geometry of a bees' honeycomb. This allows the minimization of the amount of material used to reach minimal weight & material cost while exhibiting the maximum strength possible for that design. It is then 'sandwiched' (laminated) between 2 aluminium skins on either side.
Aluminium honeycomb panels are commonly referred to as 'sandwich panels' and have been widely used in Singapore for applications such as linkway roof coverings, bus stop shelters, column covering and interior wall cladding.
Most common thickness utilised are generally 10mm and 22mm thick panels. These panels are non-combustible (BS 476 Part 4) and meet all the various fire restrictions in Singapore.
Aluminium honeycomb specifications, brochure & test reports will be given out upon request.
Stone Honeycomb Panel
Stone Honeycomb Panels are sandwich panels made up of a thin natural stone veneer reinforced with an aluminum honeycomb backing. The stone veneer can be almost any stone including granite, marble, limestone, travertine and onyx.
Combining the technology of aluminum honeycomb with the timeless beauty of natural granite, marble and limestone, it can be used for a wide variety of applications including those typically considered weight or cost-prohibitive. They have been used extensively in exterior, interior, renovation, elevator, and specialty applications.
Stone Honeycomb Panel average weight is 16 kg/m², which is approximately 80% less weight than solid stone. This weight savings alone provides huge savings in installation labor, structural requirements, and installing time.
Application of Aluminium Honeycomb panel/ Stone honeycomb panel :
Exterior wall cladding
Interior wall cladding
Linkway / walkway roof covering
Pedestrian overhead bridge roof covering
Lightweight Stone Honeycomb Table Top